You Asked It!

Take Time to Vent!

When using a pressure canner, it is very important to vent the air out of the canner before pressurizing. Air trapped in a pressure canner lowers the temperature obtained for a given pressure (for example, 10 or 15 pounds pressure) and results in underprocessing. To be safe, USDA recommends that ALL pressure canners must be vented 10 minutes before they are pressurized.

To vent a canner, leave the vent pipe (steam vent) uncovered (or manually open the petcock on some older models) after you fill the canner and lock the canner lid in place. Heat the canner on high until the water boils and generates steam that can be seen escaping through the open vent pipe or petcock. When a visible funnel-shape of steam is continuously escaping the canner, set a timer for 10 minutes. After 10 minutes of continuous steam, you can close the petcock or place the counterweight or weighted gauge over the vent pipe to begin pressurizing the canner.

Source: https://nchfp.uga.edu/publications/uga/using_press_canners.html

About Karen Blakeslee

The Rapid Response Center was formed in 1995 as a resource for Kansas State University Research & Extension Agents. Resource topics included Food Science, Human Nutrition, Food Service, Textiles, Home Care and other consumer topics. Since that time, the Center has grown to be of valuable assistance to Kansas State University Extension Specialists in those areas.

Leave a Reply

Your email address will not be published. Required fields are marked *